Filter
Top Products
8
MAIN SECTION
The XM610 has two internal power amplifiers and
depending on the power amp MODE selection
switch, the amplifiers are sent the MAIN or MONI-
TOR bus signal. The following section describes the
MAIN bus operation, which allows you to adjust the
over-all tone and volume, and specify the mix level of
the built-in effects.
Graphic Equalizer
The XM610’s 7-band Graphic Equalizer allows
you to contour the frequency response of the
MAIN mix bus signal, providing a maximum of
12dB of cut/boost for each frequency band.
This is an especially useful tool for cutting fre-
quencies that cause annoying feedback. The
frequency response is flat when the sliders are
in the center position. Moving a slider in the
positive direction will boost that frequency by as
much as 12dB, and moving the slider in the
negative direction will cut that frequency by up
to 12dB. Once you set a response curve using the Graphic Equalizer, the EQ curve is applied to both the
MAIN bus signal that is output to the speakers, and the line level signal which is output from the MAIN OUT
jack.
EFX RETURN - Effects Return Control
The EFX RETURN control is used to adjust the level of the effect sound being sent back from the built-in
digital effect to the MAIN mix bus. This allows you to hear the DSP effects in your MAIN speakers.
MASTER - Volume Control
The MASTER level control is the over-all volume control for the MAIN bus. The MAIN level affects both
the MAIN bus signal which is output to the speakers and the line level signal which is output from the
MAIN OUT jack.
Output Level Meter
The OUTPUT LEVEL METER allows you to monitor the level of the signal which is being sent to the MAIN
OUT jack (input/output panel 8).
NOTE: To avoid distortion, adjust the MASTER LEVEL control so that the 0 indicator LED lights occasionally.
15
15
Controls and Functions
FRONT PANEL CONTROLS
12
13
14
13
14
12