Filter
Top Products
Using operating menu
17
After switch-on
After switch-on, the standard display is shown on the LC display panel ¿. Depending on the
setting, the transmission frequency, the channel number or the name of the transmitter is
displayed.
Displaying the menu settings in display mode
In display mode, and with the lock mode activated, you can display the current menu settings
one after the other (see “Overview of the menus” on page 19). After a few seconds, the display
returns to the standard display.
Changing to the selection mode
To change from display mode to selection mode, you have to deactivate the lock mode.
̈ Deactivate the lock mode as described in the chapter “Deactivating the autolock function
temporarily” on page 13. You can now select the menu whose settings you want to adjust.
̈ Press the multi-function switch ¾ (switch position țSET).
You change to the menu that was displayed in display mode.
Selecting a menu
Changing to the setting mode of a selected menu
̈ Slide the multi-function switch ¾ to the position ̆ (UP) or ̄
(DOWN) to display the menu settings. If you slide the multi-function
switch repeatedly to the same position, all menu settings are
displayed one after the other.
̈ Slide the multi-function switch ¾ to the position ̆ (UP) or ̄
(DOWN).
̈ Press the multi-function switch ¾ (switch position țSET).
The name of the selected menu starts flashing.
̈ Press the multi-function switch ¾ (switch position țSET).
You change to the setting mode of the selected menu where you can
adjust settings. The current setting that can be adjusted flashes on
the LC display panel ¿.
SET
DOWN
UP
¾
SET
DOWN
UP
¾
SET
DOWN
UP
¾