Filter
Top Products
23
Attachment and Installation
Procedures
This section describes the procedures
for attaching the supplied accessories
to components and the installation of
the diversity tuner module (URX-M1)
into the MB-806A Tuner Base Unit or
SRP-X700P Powered Mixer.
Attaching the supplied
accessories to the
body-pack transmitter
(UTX-B1)
Attaching the microphone
Attaching the holder clip to
the microphone
Attaching the wind screen to
the microphone
Attaching the belt clip
Microphone (supplied)
For a secure connection, be sure to turn
and lock the connector cover.
Push the holder clip against the
bottom of the microphone until the
holder clip clicks into place.
Insert the microphone into the hole at
the bottom of the windscreen.
Insert one end of the belt clip into one
of two holes on either side of the
transmitter, and then insert the other
end into the hole on the other side.