Filter
Top Products
Settings
28
Settings
4 When the desired channel number
(or frequency) appears, set the
POWER switch to OFF to
complete the setting, or press the
SET button to set other items.
The results are stored in memory.
The stored channel number (or
frequency) will appear in the
display section the next time you
turn on the transmitter by setting
the POWER switch to ON.
Notes
• When you are setting the
transmission channel, the transmitter
cannot be used to transmit signals.
• Do not remove the batteries while
setting the transmission channel. If
they are inadvertently removed, re-
insert them immediately and redo the
procedure “Setting the transmission
channel” from step 1.
• Make sure that the selected channel
is the same on the transmitter and
tuner being used in the same system.
• If you turn off the transmitter and
then immediately turn it on right
after setting the transmission
channel, the unit may not operate
normally. Wait a few seconds before
turning it on again.
Setting the
transmission channel
The procedure below is the
same for all UWP series
transmitters (UTX-B1/H1).
See “Wireless microphone system
frequency list” on page 45 for details
on the selectable channel groups and
channels.
1 Turn on the transmitter while
pressing down the SET button.
Keep pressing the SET button
until the display section
parameters that were displayed
when the unit was last turned off
start to flash.
2 Press the SET button repeatedly
until the channel number (or
frequency) indication appears.
3 Press the + or – button to select
the channel number (or
frequency).
Pressing the + button cycles the
indication in the order shown in
the tables in “Wireless
microphone system frequency
list” on page 45.
Pressing the – button cycles the
indications in the opposite
direction.
Hold down the + or – button to
change the channel number (or
frequency) faster.