Sony UWP-C1/C2 Microphone User Manual


 
31
All the tuner modules installed
into the MB-806 are set to the
available channels within the
selected channel group.
After the automatic detection and
selection of available channels
finish, you can change the group
and channel on each tuner module
manually.
Notes
• Do the automatic detection and
selection of available channels with
the channel group other than channel
group 00.
When there are unavailable channels
due to extraneous radio wave and the
channel could not be selected on
some tuner modules, “NO CH”
appears on the display of those tuner
modules. If this happens, select the
channel group with no interference
from extraneous radio wave, and
repeat the procedure above.
Setting the attenuation
level of the audio input
The procedure below is the
same for all UWP series
transmitters (UTX-B1/H1).
The attenuation level can be set during
signal transmission.
1 Do the following while there
is no signal transmission.
Turn on the transmitter while
pressing down the SET button,
and press the SET button
repeatedly until the attenuation
level indication appears in the
display section.
Do the following while there
is signal transmission.
Press the SET button repeatedly
until the attenuation level
indication appears in the display
section.
2 Press the + or – button to select
the attenuation level.
The selectable range is from 0 dB
to 21 dB in steps of 3 dB (the
factory setting is 0 dB).
3 Do the following while there
is no signal transmission.
Set the POWER switch to OFF to
complete the setting, or press the
SET button to set other items.
The results are stored in memory.
The change becomes effective the
next time you turn on the
transmitter by setting the POWER
switch to ON.