Filter
Top Products
29
Setting the reception
channel
The procedure below is the
same for all UWP series tuners
(URX-P1/R1/M1).
See “Wireless microphone system
frequency list” on page 45 for details
on the selectable channel groups and
channels.
1 Press down the SET button for
more than one second.
Keep pressing the SET button
until the display section
parameters start to flash.
2 Press the SET button repeatedly
until the channel group and the
channel number indications
appear.
The channel group indication
starts to flash.
3 Press the + or – button to select
the channel group.
Pressing the + button cycles the
indication in the order shown in
the tables in “Wireless
microphone system frequency
list” on page 45.
Pressing the – button cycles the
indications in the opposite
direction.
Example: When the channel group 00
is selected
Hold down the + or – button to
change the channel group faster.
4 When the desired channel group
number appears, press the SET
button.
The selected group is entered.
The right four digits start to flash
to allow the selection of the
channel number.
5 Press the + or – button to select
the channel number.
The channel indication changes in
the order shown in the tables in
“Wireless microphone system
frequency list” on page 45.
6 When the desired channel number
appears, leave the tuner for about
10 seconds until the selected
channel number stops flashing and
the selection is stored in memory.