Filter
Top Products
Settings
50
• Make sure that the selected channel
is the same on the transmitter and
tuner being used in the same system.
• If you turn off the tuner and then
immediately turn it on right after
setting the reception channel, the unit
may not operate normally. Wait a
few seconds before turning it on
again.
Detecting and selecting
the available channels
automatically (diversity
tuner module (URX-M1)
only)
When multiple diversity tuner
modules (URX-M1) are installed into
the MB-806 to perform simultaneous
multiple-channel operation, select the
channel group on the tuner module
installed into the slot 1 of the MB-
806, then all the tuner mudules
installed into the MB-806 can be set to
different channels within the selected
channel group.
1 Turn off all the microphones and
transmitters.
2 Select the channel group on the
tuner module installed into the
slot 1 of the MB-806.
3 After confirming that the channel
group indication has stopped
flashing (about 10 seconds after
you have selected the channel
group), keep pressing the + button
on the tuner module installed into
the slot 1 of the MB-806.
All the tuner modules installed
into the MB-806 are set to the
available channels within the
selected channel group.
After the automatic detection and
selection of available channels
finish, you can change the group
and channel on each tuner module
manually.
Notes
• Do the automatic detection and
selection of available channels with
the channel group other than channel
group 00.
• When there are unavailable channels
due to extraneous radio wave and the
channel could not be selected on
some tuner modules, “NO CH”
appears on the display of those tuner
modules. If this happens, select the
channel group with no interference
from extraneous radio wave, and
repeat the procedure above.
Setting the attenuation
level of the audio input
The procedure below is the
same for all UWP series
transmitters (UTX-B1/H1/P1).
The attenuation level can be set during
signal transmission.
1 Do the following while there
is no signal transmission.
Turn on the transmitter while
pressing down the SET button,
and press the SET button
repeatedly until the attenuation
level indication appears in the
display section.