Filter
Top Products
U BOOTH
The output value of the BOOTH is set at 0dBu. It can be
adjusted via the control knob BOOTH (49)
NOTE : BOOTH output is not affected by any balance/pan
setting (50).
V MASTER 2
The output MASTER 2 is identical to MASTER 1. It has an
output impedance of +6dBu, which can be adjusted by the
MASTER 2 control.
W DIGITAL OUTPUT
The digital output of the VRM10 is equipped in the S/P DIF
standard. The signal path is switched parallel with MASTER
2 and can be controlled via the MASTER 2 (52) knob.
NOTE: To achieve the optimum sound performance and
lowest signal-to-noise ratio it is essential in the digital out-
put section to set the output impedance of the mixer to the
highest possible level (control 52) and if necessary to lower
the volume of the digital equipment connected to the
VRM10 receiving signal.
2
CONTROL INTERFACE (Front Panel)
1 Power On/Off
2 LED Power
After pressing the VRM10’s power switch, the blue power
LED will light up right away. The valves in the signal path of
the VRM10 will light up fully after a warm up period of 1-2
minutes.
The main outputs of the VRM10 (MASTER 1+ 2 and
BOOTH) are equipped with a special patented circuitry
to prevent crackling noise in the signal while switching
the unit on or/and off. In any case you should make sure,
that the mixer is switched on before the rest of your
equipment, i.e. especially amplification e.g. This will pre-
vent possible damage to you speakers and PA system.
When turning off your equipment, you should proceed
the opposite way; this means: first turn off the amplifica-
tion, then the VRM10 mixer.