Filter
Top Products
IMPORTANT SAFETY PRECAUTIONS
32 TASCAM CD-RW900SL32 TASCAM CD-RW900SL
Messages during operations
Message Statement
Blank Disc A blank recordable disc has been inserted.
Complete An operation such as finalize or erase has been successfully completed.
Now OPC* Calibration is being performed to operate recording properly.
Disc Repair The disc is being repaired, and this operation will take a long time. Please do not turn off the power
of the CD-RW900SL until it finishes.
PMA Writing* The recorded content is being written to the disc.
TOC Reading The table of contents data is being read.
*OPC=Optimum power Control
*PMA=Program memory Area
Error messages
Message Details / response
Can’t Rec! Cannot record. Either erase the contents of the disc (for a CD-RW), or use a
different recordable disc.
Disc Error! The disc has malfunctioned. Please replace with a new disc.
Disc Full! No recording time remaining, or no recordable track is left on the disc.
Text Full! No space to input the letters.
Sure? Text! The text data is not written on the disc yet. Eject the disc to cancel the text
you entered or perform the finalize operation to write the data to the disc.
Drive Error! There is a problem in the drive.
D-IN UNLOCK! The digital input is not connected. Turn on the power of the equipment
connected to DIGITAL IN.
Not Audio! There is no audio signal from DIGITAL IN.
Erase Error! An error occurred while erasing.
Not Fs44.1k! The sampling frequency of the digital input is not 44.1 kHz. Please turn the
SRC on.
PGM Empty! There is no program.
PGM Full! No new programs can be created.
Can’t Edit! Editing cannot be performed due to operational restrictions.
Can’t Sel! Menu selection cannot be performed due to selection restrictions.
Rec Error! There was an error during recording. Please re-record.
OPC Error! There was an error during OPC. Please re-record.
No DIR! There is no directory that contains a file.
Decode Err! The MP3 file cannot be played back.
Format Err! The disc is in a format that the CD-RW900SL cannot read.
IR Disable! Remote control operation is not allowed.
8 − Reference and specifications