Filter
Top Products
TASCAM M-164/M-164FX/M-164UF
25
Using a record player
An analog record player can be directly connected to mixer
channels 9-10.
Make the following connections and settings to use an
analog record player with this mixer.
Connect the record player audio output to the channel
•
9-10 input jacks on the rear panel of the mixer.
Connect the record player grounding wire to the
•
SIGNAL GND jack on the rear panel of the mixer.
Record player
Turn the
•
PHONO ON switch on the top panel ON (push
switch in).
The output signals of analog record players are different
from ordinary line output signals. If the connections and
settings described above are not made, the playback
sound will not be correct.
Making final adjustments to the main
output sound
The stereo bus has a 2-band EQ with HI and LOW shelving
that can be used to adjust the sound of the mix overall.
The EQ HI and EQ LOW knobs can boost and cut the high
and low frequency ranges by ±15 dB.
Use the EQ HI knob to boost or cut the frequency band
above 12 kHz, and use the EQ LOW knob to boost or cut
the frequency band below 100 Hz.
4 − Using the mixer