Filter
Top Products
TASCAM RC-F82 11
3 – Preparations
Connecting with an HS-P82
Use the included cable to connect the MAIN UNIT
connector on the left side panel of this unit with the
KEYBOARD connector on the HS-P82 unit. If you want
to use an external PS/2 keyboard with the HS-P82 unit,
connect the keyboard to this unit’s KEYBOARD connector.
CAUTION
Connect and disconnect the connection cable only
•
when the HS-P82 unit power is OFF. Connecting and
disconnecting the cable when the power is ON could
cause damage to the HS-P82 and the fader units.
The unit might not function properly if a PS/2 keyboard
•
that consumes a large amount of power is used.
Connecting with other
equipment
If you connect the HS-P82 unit’s LINE OUT connectors to
this unit’s LINE IN connectors, you can output its signal
from both the LINE OUT 1 connectors and LINE OUT 2/
TALKBACK connectors on this unit. The HS-P82 unit only
allowed a single line output connection, but through this
unit two output connections are possible.
CAUTION
When the TO LINE OUT 2 switch is ON, the HS-P82 unit’s
line output signal will not be output from the LINE OUT
2/TALKBACK connectors. If you want to output the line
output signal from these connectors, set this switch to
OFF.
Using communication functions
Connect the PHONES jack on the HS-P82 to the PHONES
IN jack on this unit, and connect the outputs from
devices that you want to receive communication from
to this unit’s RETURN IN connectors. By doing this, you
can monitor an analog mix of these signals through
headphones connected to this unit’s PHONES jack.
Connect the LINE OUT 2/TALKBACK connectors to the
inputs on the devices that you want to communicate
with and use the outputs of those devices to listen to
communication from this unit’s built-in microphone.
Example of connections for using the communication
functions
For details about using these features, see, “6 –
Communication Functions” on page 16.