Filter
Top Products
TASCAM RC-F82 9
Rear panel
2 – Names and Functions of Parts
l LINE IN connectors (left and right)
These are balanced XLR analog input connectors
(1: GND, 2: HOT, 3: COLD). Connect them with the
HS-P82 LINE OUT connectors.
; LINE OUT 1 connectors (left and right)
These are balanced XLR analog output connectors
(1: GND, 2: HOT, 3: COLD). The signals input through
the LINE IN connectors (left and right) are passed
through and output from these.
z LINE OUT 2/TALKBACK connectors
These are balanced XLR (left and right) analog output
connectors (1: GND, 2: HOT, 3: COLD). When the TO
LINE OUT 2 switch is set to OFF, the signal input
through the LINE IN connectors are passed through
and output from these. When the TO LINE OUT 2
switch is set to ON, the talkback signal is output from
these connectors.
x RETURN IN connectors (1/2)
These are balanced XLR analog input connectors
(1: GND, 2: HOT, 3: COLD). Use these connectors for the
input of talkback signals. The signals input through
these connectors are mixed in the analog domain with
the signal input through the PHONES IN jack and then
the mix is output through the PHONES jack.
c PHONES IN jack
This standard stereo phone jack is an analog input
connector. Connect it to the PHONES jack of the
HS-P82 unit. The signal input through this connector
is mixed in the analog domain with the signals input
through the RETURN IN connectors and then the mix
is output through the PHONES jack.
Front panel
v PHONES jack
Use this standard stereo phone jack to connect
headphones. Use the PHONES knob on the top panel
to adjust the headphones output level.
CAUTION
Before connecting headphones, turn the PHONES knob
to the minimum volume. Failure to do so could cause
sudden loud noises to occur, which might damage your
hearing or equipment.