Filter
Top Products
3.2 Handheld Transmitter Setup3.2 Handheld Transmitter Setup
1.
Insert battery.Slide open the hinged battery compartment cover
by placing your thumb on the indents of the battery door (at the
bottom of the transmitter) and gently pushing down (see Figure
9). Insert the battery, terminal end first, into the compartment,
with the smaller positive terminal to the right.
2.
Set handheld transmitter channel to match the channel setting
on the receiver (channel number displayed on front of receiver
panel). The channel setting on the handheld transmitter is ac-
cessed through the round opening on the side of the mic housing.
Numbers 0 - 9 are printed around the opening. The channel set
-
ting is determined by which number the arrowed slot is pointing
to. Use a small screwdriver (supplied) to change the channel set
-
ting. See Figure 10.
3.
Turn on the transmitter by sliding the power switch (closest to
the battery compartment) forward to the ON position (toward the
windscreen). The red battery condition light should flash once
and then go out. If the red light stays on or illuminates during a
performance, the battery should be replaced immediately. The
green light will stay lit when the handheld transmitter is on.
Note: Remember to turn the transmitter OFF when not in use.
This will conserve battery life.
-11-
SLIDE BATTERY DOOR BACK
SWING DOOR UPWARD
POWER
SWITCH
MIC
SWITCH
Telex
R
elex
Telex
R
elex
Figure 9
GAIN
ADJUST
9
1
0
2
3
4
5
6
7
8
CHANNEL SET
SWITCH
9
1
0
2
3
4
5
6
7
8
e
lex
R
T
elex
Figure 10