Filter
Top Products
3.3 Bodypack Transmitter SetupTransmitter Setup
1.
Insert battery. Open the hinged battery compartment by placing
your thumb or finger on the indent labeled OPEN on the battery
door and pushing down, see Figure 11. When inserting the bat
-
tery, pay attention to the polarity (+/-) and insert the terminals
into the battery compartment first. Close the battery door by slid
-
ing the door shut.
2.
Set the transmitter channel to match the channel setting on the
receiver. The channel switch on the bodypack is located just un
-
derneath the battery door, and to the right of the indent labeled
OPEN. Note the channel number label (0-9) surrounding the
opening. The bodypack channel must be set to the same number
as the receiver channel, which is displayed on the receiver front
panel. The channel setting is determined by which number the
arrowed slot is pointing to. Use a small screwdriver (supplied)
to change the channel setting.
-13-
BELT CLIP MAY BE TURNED
90 DEGREES BY REMOVING
SCREW AND REINSTALLING
HERE.
GAIN
ADJUSTMENT
DOOR OPENED
BUT NOT
SWUNG UPWARD
SWING DOOR
UPWARD TO
ACCESS BATTERY
COMPARTMENT
TO OPEN BATTERY DOOR
PRESS ARROW WITH INDEX
FINGER AND PULL DOWN WITH
THUMB AND MIDDLE FINGER
CHANNEL
SWITCH
Figure 11
Channel Switch