Filter
Top Products
Recalling the Registered Panel Setups
CVP-305/303/301 Owner’s Manual
122
Registering and Recalling Custom Panel Setups
Saving the Registered Panel Setups
You can save all the eight registered panel setups as a single Registration Memory
Bank file.
1 Press the REGISTRATION MEMORY [REGIST. BANK] button to call up
the REGISTRATION BANK Selection Display.
2 Press the [6
††
††
] button to save the Bank file (page 63).
Recalling the Registered Panel Setups
1 Press the REGISTRATION MEMORY [REGIST. BANK] button to call up
the REGISTRATION BANK Selection Display.
2 Press one of the [A]–[J] buttons to select a bank.
3 Press one of the green-lit numbered buttons ([1]–[8]) in the Registra-
tion Memory section.
Bank 1
Bank 2
Bank 3
Bank 4
R
eg
i
strat
i
on
M
emory
d
ata
compatibility
In general, Registration Memory
data (Bank files) is compatible
among the models CVP-309/
307/305/303/301. However, the
data may not be perfectly com-
patible, depending on the speci-
fications of each model.
1
2
Ab
out reca
lli
ng setups
f
rom a
SmartMedia card or floppy
disk
When recalling the setups
including Song/Style file selec-
tion from a SmartMedia card or
floppy disk, make sure that the
appropriate SmartMedia card or
floppy disk including the regis-
tered Song/Style is inserted into
the card slot or floppy disk drive.
1
3
2
2
Parameter Lock
You can “lock” specific parameters (e.g., effect, split point, etc.) to make them
selectable only via the panel controls—in other words, instead of via Registration
Memory, One Touch Setting, Music Finder, Song or incoming MIDI data, etc.
Call up the Parameter Lock display ([FUNCTION] → [I] UTILITY → TAB [
√
]
CONFIG 1 → [B] 3 PARAMETER LOCK). Select the desired parameter by
using the [1
π†
]–[7
π†
] buttons, then lock it with the [8
π
] (OK) button.