Filter
Top Products
Appendix
CVP-305/303/301 Owner’s Manual
204
CVP-303: Keyboard Stand Assembly
CAUTION
• Be careful not to confuse parts, and be sure to install all
parts in the correct direction. Please assemble in accor-
dance with the sequence given below.
• Assembly should be carried out by at least two persons.
• Be sure to use the correct screw size, as indicated below.
Use of incorrect screws can cause damage.
• Be sure to tighten up
all screws upon com-
pleting assembly of
each unit.
•To disassemble,
reverse the assembly
sequence given below.
1 Open the package, take out the pedal box, take
out the styrofoam pads, and place the main unit
on top of the pads.
Position the pads so that they will protect the headphone
jack located underneath the front left corner.
Remove the parts shown below from the box.
2 Attach the side panels to the pedal box.
3 Attach the rear panel.
1
Place the bottom edges of the rear panel on the feet’s
protruding edges, with the panel slightly angled as shown in
the illustration. Then, align the top part of the panel with the
side panels.
2 Secure the top of the rear panel to the side panel brackets
using two 4x12 mm thin screws.
3 Secure the bottom of the rear panel to the pedal box using
four 4x20 mm tapping screws.
4 Mount the main unit.
Be sure to place your hands at least 10 cm
from either end of the main unit when posi-
tioning it.
Have a Phillips-head (+) screw-
driver ready.
Main unit
Phones jacks Styrofoam pads
To prevent the key cover
from accidentally open-
ing during assembly,
press down on the key
cover, making sure that
the sheet (shown)
remain in place.
Bundled pedal cord inside
Rear panel
Pedal box
Side panel
(left)
Side panel
(right)
Assembly Parts AC power cord
6 x 25 mm long screws x4
4 x 20 mm tapping screws x46 x 16 mm short screws x4
Cord holders x2
4 x 12 mm thin screws x2
Side panel
(left)
Side panel
(right)
Side panel
(left)
Side panel
(right)
1 Untie and straighten out the bundled
cord attached to the bottom of the
pedal box. Don’t discard the vinyl tie,
you’ll need it later in step 6.
2 Use the four 6x25 mm long screws to attach the
pedal box. First attach one side panel, then attach
the other side panel.
CAUTION
• Fingers can become pinched between the main unit
and the rear or side panels, be extra careful so as not to
drop the main unit.
• Do not hold the keyboard in any position other than
the position shown in the illustration.
At least
10 cm
At least
10 cm