Filter
Top Products
Rhythm and Accompaniment
4
65
About the Rhythm Sequence
Rhythm Sequence is built up with various different rhythm patterns, and
can be programmed by the other Electone such as EL-700 and EL-500.
The EL-400 doesn’t have Rhythm Sequence function, but it can read and
load the rhythm sequence data recorded on the MDR (a floppy disk) to its
four SEQ buttons in the Rhythm section and play back them, as follows:
1. Insert the floppy disk containing rhythm sequence data into the EL-400’
s MDR slot. The rhythm sequence data is recorded as a part of
registration data (explained on page 78).
2. Select the song number containing the registration data and press PLAY
button on the MDR to load the data. The rhythm sequence data has been
loaded to the Electone, or SEQ button(s).
3. Press the desired SEQ button. The SEQ button’s lamp will be lit.
SEQ.
1
SEQ.
2
SEQ.
3
SEQ.
4
RHYTHM
MAX
MIN
MARCH WALTZ SWING BOUNCE SLOW
ROCK
1
TANGO LATIN
1
LATIN
2
8 BEAT 16 BEAT
2
NOTE:
You can have up to all four rhythm
sequences play back automatically by
pressing the SEQ buttons.
4. Turn the START button on and play the rhythm sequence(s).
RHYTHM
SYNCHRO
START
START
FILL IN
INTRO.
ENDING
During the rhythm sequence playback, the rhythm name currently
played back is displayed on the LCD.
NOTE:
Four types of metronome sounds,
simple metronome, two four, three four
and four four, are assigned to the SEQ 1
– 4 buttons, respectively, as the
defaults. (page 72)
NOTE:
As soon as you load the sequence data
using MDR, the default settings on each
SEQ button, four types of metronome
sounds, will be overwritten, or lost.
If you want to restore the default
settings, execute Power On Reset (page
72) operation.
Also, pressing any of the BASIC
REGIST buttons generates a short beep
sound and retrieves the metronome
sounds.