Filter
Top Products
M7CL Owner’s Manual
Operations in the SELECTED CHANNEL section
92
●
Adjusting the send level to a MIX bus or
MATRIX bus
Use the TO MIX/TO MATRIX field when you want to
send the signal from an INPUT/ST IN channel to a MIX
bus, or from an INPUT, ST IN, MIX, or STEREO channel
to a MATRIX bus.
1
TO MIX/TO MATRIX buttons
(Input channels only)
These buttons select the buses that will be controlled.
This field will show the MIX buses if the TO MIX but-
ton is on, or the MATRIX buses if the TO MATRIX
button is on.
B
TO MIX/TO MATRIX SEND LEVEL knobs
These knobs indicate the send level of the signal sent
from that input channel to each MIX bus or MATRIX
bus. To adjust the values, use the corresponding [MIX/
MATRIX] encoder of the SELECTED CHANNEL
section.
If the send-destination MIX bus / MATRIX bus is set
to stereo, the left knob of the two adjacent knobs will
operate as a PAN knob. (For a ST IN channel, a stereo
MIX channel, or STEREO channel, it will operate as
the BALANCE knob.) When you press this knob, the
corresponding MIX/MATRIX SEND popup window
will appear.
C
TO MIX/TO MATRIX SEND ON/OFF but-
ton
These are on/off switches for the signal sent from the
channel to each MIX bus / MATRIX bus.
To adjust the send level to MIX buses or MATRIX buses,
first use the TO MIX / TO MATRIX buttons to select the
buses to which you want to send the signal (only for input
channels).
Next, use the corresponding [MIX/MATRIX] encoders of
the SELECTED CHANNEL section (color-coded in the
screen) to adjust the send levels of the signal sent to each
bus.
If desired, you can use the TO MIX/TO MATRIX SEND
ON/OFF buttons to switch the signal sent to each bus on/
off. Above each of these buttons is shown the position
from which the signal is sent from the current channel.
(For details on changing the send position
→
p. 70).
●
Adjusting the send level from the MIX
channels to a specific MATRIX bus
To adjust the send level from the MIX channels to a spe-
cific MATRIX bus, first select the send-destination
MATRIX channel, and then access the SELECTED
CHANNEL VIEW screen. If you have selected a
MATRIX channel, the FROM MIX field is shown at the
left edge of the SELECTED CHANNEL VIEW screen.
This field includes the following items.
1
FROM MIX SEND LEVEL knobs
These adjust the send level of the signal sent from
each MIX channel to the selected MATRIX bus.
B
FROM MIX SEND ON/OFF buttons
These are on/off switches for the signal sent from each
MIX channel to the MATRIX bus.
To adjust the send level from a MIX bus, turn the corre-
sponding [MIX/MATRIX] encoder in the SELECTED
CHANNEL section (they are color-coded as in the
screen).
If desired, you can use the FROM MIX SEND ON/OFF
buttons to switch the signal sent from each MIX channel
to the MATRIX bus on/off. Above each of these buttons is
shown the position from which the signal is sent from the
MIX channel. (For details on changing the send position
→
p. 87).
Subsequent operations will differ depending on the
parameters you want to adjust.
3
1
2
• If the send-destination MIX bus is a FIXED type, this knob will
not appear; only the TO MIX SEND ON/OFF button (
3) will
be shown.
NOTE
2
1