Filter
Top Products
Using the n8/n12 with Cubase 5 series
Owner’s Manual
35
English
7.
Select New Project from the File menu to create a
new project.
The Project Assistant panel opens.
Two templates each are provided for the n8 and
n12. These templates contain audio I/O and other
preset data. You can start recording immediately
after opening one of these templates.
■ Yamaha n12 multi channel recording
■ Yamaha n8 multi channel recording
An individual input channel signal on the n8/n12 will be
directly routed to each audio track in Cubase.
■ Yamaha n12 stereo recording
■ Yamaha n8 stereo recording
The REC bus signals on the n8/n12 will be routed to the
Cubase audio tracks.
8.
Click the name of the template you wish to use,
then click [OK].
9.
When the directory selection dialog box opens,
specify a folder in which you wish to store the
created project file and other audio files. Then
click [OK].
A project window based on the selected template
opens.
• If an n8/n12 project template is not displayed, the
n Extension may not be installed correctly. Refer
to the “TOOLS for n Version2/Cubase AI
Installation Guide” for instructions on installing the
software again.
• For more information on the templates, please
refer to the Appendix.
project templates for n8/n12
Select the “Recording” category.
NOTE
If you want to change the Sample Rate or routing of
the input/output bus, follow the instructions below.
■ To change the Sample Rate:
Select [Project] ➝ [Project Setup] to call up the
Project Setup dialog.
After setting, click [OK] to close the dialog.
According to the setting made here, the Sample
Rate of the n8/n12 will be changed automatically.
■ To change the routing of the input/output bus:
Select [Devices] ➝ [VST Connections] to call up the
VST Connections window. From this window, you
can change the device port of the existing bus and
add the new bus.
Sample Rate of
the project file