Filter
Top Products
Recording Your Performance
P-140 Owner’s Manual
ENGLISH
33
Changing the Initial Settings (data recorded at the
beginning of a song)
The initial settings (data recorded at the beginning of a song) can be changed after the recording.
For example, after recording, you can change the voice to create a different ambience or adjust the
song tempo to your taste.
You can change the following initial settings.
Individual Parts
•Voice selection
• [REVERB] depth
• [EFFECT] depth
•Dual voices
• Split voices
Entire Song
•Tempo
• [REVERB] type (including OFF)
• [EFFECT] type (including OFF)
1. Press the [REC] button to engage
Record mode and select a part to
change the initial settings.
The indicator lights in red. (Data shared by two parts can
be changed via either part.)
2. Change the settings via the panel
controls.
For example, if you wish to change the recorded voice
from [ELECTRIC PIANO 1] to [ELECTRIC PIANO 2], press the [ELECTRIC
PIANO 2]
button. When you wish to change the sustain/soft pedal depth, press
and hold the pedal.
3. Press the [REC] button to exit the Record mode.
CAUTION
Be careful not to press the [PLAY/PAUSE] button or a key on the keyboard after step 2
or 3, either of which will start recording and erase all previously-recorded data on the
selected part.
1
1 3
You can cancel changes made to
the initial settings by selecting a
different part after step 2, then
exiting Record mode by pressing
the [REC] button. (Changes
made to the data shared by two
parts are also canceled.)
NOTE