Filter
Top Products
31
YPP-100
F7.3: Local Control ON/OFF ............................................................................................................
“Local Control” refers to the fact that, normally, the YPP-100 keyboard controls its internal
tone generator, allowing the internal voices to be played directly from the keyboard. This
situation is “Local Control On” since the internal tone generator is controlled locally by its
own keyboard.
Local control can be turned OFF, however, so that the YPP-100 keyboard does not play the
internal voices, but the appropriate MIDI information is still transmitted via the MIDI OUT
connector when notes are played on the keyboard. At the same time, the internal tone genera-
tor responds to MIDI information received via the MIDI IN connector.
Use the [–/NO] and [+/YES] buttons to turn local control “On” or “OFF”.
Press the [–/NO] and [+/YES] buttons simultaneously to recall the default setting “On”.
Tone
Generator
MIDI OUT
MIDI
IN
YPP-100
F7.4: Program Change ON/OFF...................................................................................................
Normally the YPP-100 will respond to MIDI program change numbers received from an
external keyboard or other MIDI device, causing the correspondingly numbered voice to be
selected on the corresponding channel (the keyboard voice does not change). The YPP-100
will normally also send a MIDI program change number whenever one of its voices is se-
lected, causing the correspondingly numbered voice or program to be selected on the external
MIDI device if the device is set up to receive and respond to MIDI program change numbers.
This function makes it possible to cancel program change number reception and transmis-
sion so that voices can be selected on the YPP-100 without affecting the external MIDI
device.
Use the [–/NO] and [+/YES] buttons to turn program change transmission and reception
“On” or “OFF”.
Press the [–/NO] and [+/YES] buttons simultaneously to recall the default setting “On”.
• For information on program change numbers for each of the YPP-100’s voices, refer to page 42 in the
MIDI Data Format section.
The Function Mode