Filter
Top Products
48
YPP-100
4
5
5 5 x 16 mm round head screws
V
Put the keyboard on the stand.
Carefully place the keyboard on the side boards.
Slowly move the keyboard so that the holes on the
bottom of the keyboard are properly aligned with the holes
on the angle brackets.
CAUTION
• Be careful not to drop the keyboard or to get your fingers
caught between the keyboard and the stand parts.
B
Install the keyboard to the stand.
Fix the keyboard to the angle brackets, using the 5 x 16
mm round head screws 5.
■ Post-assembly checklist
Once you’ve assembled the stand, check the following
points:
• Are there any parts left over?
➔ If so, read the assembly instructions again and correct
any errors you might have made.
• Is the instrument clear of doors and other movable
fixtures?
➔ If not, move the instrument to an appropriate location.
• Does the instrument make a rattling noise when you play it
or move it?
➔ If so, properly tighten all screws.
• Also, if the keyboard makes a creaking noise or seems
unsteady when you play it, refer carefully to the assembly
instructions and diagrams and retighten all screws.