Filter
Top Products
46
YPP-100
1
Z
Attach the stand bases.
Making sure that the boards are facing the proper direc-
tion (the holes should face inside), insert the joint connec-
tors 2 into the holes as shown. The joint connectors have
been installed properly if you can see a plus mark on the
connector.
Attach the stand bases to the rear of the side boards,
using the 6 x 70 mm round head screws 1 .
1 6 x 70 mm round head screws (4 pcs.)
2 Joint connectors (4 pcs.)
3 3.5 x 16 mm tapping screws (12 pcs.)
■ Assembly Parts
Back board
Side boards
Stand bases
2 Joint connectors
1 6 x 70 mm round head screws
4 6 x 30 mm round head screws (4 pcs.)
5 5 x 16 mm round head screws (4 pcs.)
6 Angle brackets (4 pcs.)
Keyboard Stand Assembly
CAUTION
• Be careful not to mismatch parts, and be sure to install all parts in the
correct direction. Please assemble in accordance with the sequence
given below.
• Assembly should be carried out by at least two persons.
• Be sure to use the correct screw size, as indicated above. Use of incor-
rect screws can cause damage.
• Be sure to tighten all screws upon completing assembly of each unit.
• To disassemble, reverse the assembly sequence given below.
Have a phillips-head (+) screwdriver ready.
The parts shown in the “Assembly Parts” illustration will be
used. Follow the assembly instructions and select the parts
as needed.