Filter
Top Products
Using the Expression Pedal (FP01/FP02)
Restoring Factory Defaults
Using the Expression Pedal
Restoring Factory Defaults
20
ZOOM 504 II ACOUSTIC
ZOOM 504 II
ACOUSTIC
21
The 504 II is equipped with a CONTROL IN jack designed for
connection of the optional expression pedal FP01 or FP02. The pedal
can be used as volume pedal or as a controller for varying effect
parameters.
For information on parameters that can be adjusted with the expression
pedal, please refer to pages 26 - 29.
1.Plug the cable from the FP01/FP02 into the CONTROL IN
jack of the 504 II, and then turn the 504 II on.
If the FP01/FP02 is plugged into the CONTROL IN jack while the 504
II is already on, malfunction may occur. Be sure to turn on the 504 II
only after connecting the expression pedal.
2.Select the patch in play mode, and
move the expression pedal back
and forth while playing your
instrument.
Depending on the program content of the patch, the volume or
effect parameter will change.
The expression pedal can also be used in edit mode to control the
volume or effect parameter.
The 504 II comes with 36 preprogrammed patches. These factory
default patches can be restored also if they were overwritten by patches
created by the user.
There are two ways of restoring factory defaults. "All Initialize" returns
the entire set of patches to the original condition. "Factory Recall"
restores a specific patch to the original condition.
1.While holding down the STORE key, plug the appropriate
cable into the INPUT jack (or DC 9V jack).
The indication "AL" flashes on the display.
To perform All Initialize
2.Press the STORE key once more.
All patch settings are returned to the factory default condition, and
the unit switches to play mode. To cancel All Initialize, press the [-]
key.
All user-created patches will be lost when performing All Initialize.
Use this function with care.
To perform Factory Recall
2.Use the [ ]/[ ] foot switches to select the patch you
want to return to the original condition.
The specified bank and patch number are flashing on
the display.
During Factory Recall, the [+]/[-] keys cannot be used to switch the
bank only.
3.
Press the STORE key once more.
The settings of the specified patch are returned to the factory default
condition.
If desired, repeat steps 2 and 3 to restore other patches. To terminate
the Factory Recall operation, press the [-] key. The unit will switch
to the play mode at this point.
NOTE
NOTE
Move back and forth