Filter
Top Products
Select the effect
parameter
Change the parameter value
Changing the parameter
on/off condition
Holding down one of these keys will
continuously change the value. Additionally
pressing the opposite key will cause a faster
change. Pressing both keys simultaneously
skips values in larger steps.
The parameter is turned off, and the indication
"oF" appears on the display. Pressing both foot
switches together once more turns the
parameter on again.
This operation is not possible for the patch
level and TYPE parameters (step ,
parameters (1) and (2)).
Use the [+]/[-] keys.
Use the [PLAY/EDIT] selector to
select the effect you want to
change.
The value of the currently
selected parameter is
shown on the display.
(When the 504 II is in edit
mode, a dot (.) is shown in
the bottom right section of
the display.)
Terminate the edit mode
To terminate the edit mode and return to the
play mode, set the [PLAY/EDIT] selector to the
"PLAY" position.
Parameter
value
Lit
Parameters selectable with
[PLAY/EDIT] selector
(1) Patch level
(2) TYPE parameter
(3) LIMIT/EDGE parameter
(4) LOW/BODY parameter
(5) HIGH/TOP parameter
(6) AIR parameter
(7) EFFECT parameter
(8) DLY&REV parameter
(9) De-AMP parameter ( )
(10) F.B.SUPPRESSOR
parameter ( )
= global parameter
NOTE
Unless you store the edited patch in memory, the
settings you made will be lost when you select a
different patch after returning to the play mode. Do
not forget to store an edited patch that you wish to
keep, as described on page 14.
(1)
(2)
(3)
(5)
(4)
(6)
(7)
(8)
(9)
(10)
Press both [ ]/[ ] foot switches
together.
Editing a Patch
Editing a Patch
Editing a Patch
The patches of the 504 II can be freely edited by changing the effect
parameter settings. Try editing the currently selected patch to create
your own sound.
Editing a Patch
12
ZOOM 504 II ACOUSTIC
ZOOM 504 II
ACOUSTIC
13