Filter
Top Products
Changing the "Patch
call" method to
pre-select
To change the "Patch call" method to pre-
select, you must turn the unit on while
holding down the [ ] foot switch.
Specifying the
desired patch
You can also use the [+]/[-] keys to only
switch the bank.
The bank and patch
number of the patch to
be used next will be
shown on the display,
but the sound does not
yet change.
Confirm the patch
change
When the desired patch is shown, press
the [ ]/[ ] foot switches together.
The patch change is
confirmed, the sound
changes, and the display
stops flashing and stays
constantly lit.
This will return the patch select method to the
default setting.
Changing the "Patch
call" method back to
direct select
To change the "Patch call" method
back to normal direct select
operation, simply turn the unit off
and back on again.
Confirm
Use the [ ]/[ ] foot switches to
select the patch you want to use
next.
Changing the "Patch Call" Method
Changing the "Patch Call" Method
Changing the "Patch Call" Method
In normal operation, the sound of the 504 II will change immediately if
a patch is selected in play mode. This may be undesirable if a patch
from a distant memory location is called and the sound of other
unwanted patches in between is heard. If desired, you can change the
"Patch call" method from direct selection to the pre-select method. In
pre-select mode, you first specify the desired patch and then confirm
the selection. The sound will only change after you have confirmed the
operation.
Changing the "Patch Call" Method
16
ZOOM 504 II ACOUSTIC
ZOOM 504 II
ACOUSTIC
17