MPOA Devices Configuration
227
MPOA Server Configuration Parameters
Table 29 describes the MPOA Server configuration parameters.
.
Table 29 MPOA Server Configuration Parameters
Variable Name Description
MPS-p1 keep-alive time The MPS must transmit MPOA keep-alives every MPS-p1 seconds.
(Minimum = 1 sec., default = 10 sec., maximum = 100 sec.)
MPS-p2 keep-alive lifetime The length of time (in seconds) an MPC may consider a keep-alive valid.
(Minimum = 3 sec., default = 35 sec., maximum = 1000 sec.)
MPS-p3 internetwork-layer
protocols
The set of protocols for which MPOA resolution is supported. Default = ().
MPS-p4 MPS initial retry time Initial retry time used by the MPOA retry mechanism. (Minimum = 1 sec.,
default = 5 sec., maximum = 300 sec.)
MPS-p5 MPS retry time
maximum
Maximum retry time used by MPOA retry mechanism.
(Minimum = 10 sec., default = 40 sec., maximum = 300 sec.)
MPS-p6 MPS give up time Minimum time to wait before giving up on a pending resolution request.
(Minimum = 5 sec., default = 40 sec., maximum = 300 sec.)
MPS-p7 default holding time Default holding time used in NHRP resolution replies. An egress MPS may
use local information to determine a more appropriate Holding Time.
(Minimum = 1 minute., default = 20 minutes, maximum = 120 minutes.)
