236
C
HAPTER
9: M
ANAGING
LAN E
MULATION
MPOA Client Configuration Parameters
Table 30 describes the MPOA Client configuration parameters.
Table 30 MPOA Client Configuration Parameters
Variable Name Description
MPC-p1 shortcut-setup frame time If an MPC forwards at least MPC-p2 frames to the same target
within any period MPC-p1 via the default forwarding path, it should
initiate the procedure to establish a shortcut. The MPC-p1 and
MPC-p2 parameters specify a default mechanism for automatically
detecting flows in the absence of other information. Other
mechanisms (e.g. RSVP) may be used in specific cases to override
this default.
(Minimum = 1 sec., default = 1 sec., maximum = 60 sec.)
MPC-p2 shortcut-setup frame count See MPC-p1.
(Minimum = 1 sec., default = 10 sec., maximum = 65535 sec.)
MPC-p3 flow detection protocols A set of protocols on which to perform flow detection.
Default = ().
MPC-p4 MPC initial retry time Initial retry time used by the MPOA retry mechanism.
(Minimum = 1 sec., default = 5sec., maximum = 300 sec.)
MPC-p5 MPC retry time maximum Maximum retry time used by the MPOA retry mechanism.
(Minimum = 10 sec., default = 40 sec., maximum = 300 sec.)
MPC-p6 hold down time Minimum time to wait before reinitiating a failed resolution
attempt. This is usually set to a value greater than MPC-p5.
(Minimum = 30 sec., default = MPC-p%*4, maximum = 120 sec.)
