A SERVICE OF

logo

CHAPTER 3: INSTALLATION
13
Figure 3-1. ServSelect II Horizontal Installation
To install the 1U switch mounting bracket:
1. Remove the fi rst two screws on each side.
2. Line up the holes in the “long side” of the kit s side brackets with the screw
holes in the switch.
3. With a Phillips screwdriver, fasten the mounting brackets to the switch using
two screws on each side.
4. Attach four cage nuts or clip nuts to the rack mounting fl ange of the rack
cabinet so that the nut is positioned on the inside of the rack.
NOTE:
Nuts are not included with the rack mount kit.
5. Mount the switch assembly to the rack cabinet by matching the holes in the
“short side” of each bracket to an appropriate set of matching holes on your
rack cabinet. Next, insert the combination hex head screws through the slots in
the bracket and the holes in the mounting rail, then into the cage nuts or clip nuts.