CHAPTER 4: BASIC OPERATIONS
31
5. In the Sec column, type the number of seconds (from 3 to 255) of desired time
before the scan moves to the next server in the sequence.
6. Move the cursor to the next line or press the
Down Arrow and repeat steps 2-5 for
each of the remaining servers to be included in the scan pattern.
7. Click OK.
To remove a server from the scan list:
1. In the Scan dialog box, click the server to be removed.
2. Press
Delete.
-or-
Press
Shift+Delete to remove the selected server and all entries below it.
3. Click OK.
To start the scan mode:
1. Press
Print Screen. The Main dialog box will appear.
2. Click Commands. The Commands dialog box appears.
Figure 4-15. Commands Dialog Box
3. Select Scan Enable in the Commands dialog box.
4. Click X to close the Commands dialog box.
NOTE:
Scanning will commence when the Main dialog box or fl ag is displayed. Scanning is inhibited in
any other OSD dialog box.
To cancel scan mode:
1. Select a server if the OSD is open.
-or-
Move the mouse or press any key on the keyboard if the OSD is not open.
Scanning will stop at the currently selected server.
-or-
Press
Print Screen. The Main dialog box will appear.
