SERVSELECT II™ INSTALLER/USER GUIDE
22
2. Type a name in the New Name box. Names of servers may be up to 15 characters
long. Legal characters include: A-Z, a-z, Ø-9, space and hyphen.
3. Click OK to transfer the new name to the Names dialog box. Your selection is
not saved until you click OK in the Names dialog box.
4. Repeat steps 1-3 for each server in the system.
5. Click OK in the Names dialog box to save your changes.
-or-
Click X or press
Escape to exit the dialog box without saving changes.
NOTE:
If an SAM has not been assigned a name, the EID is used as the default name.
Assigning device types
While the appliance automatically discovers cascade ServSelect switches attached to
your unit, you will need to specify the number of ports on the cascade switch through
the Devices dialog box. You will see an Sw-8 or Sw-24 appear in the Type category
for the cascade switch. Select the switch from the list and the Modify button appears,
allowing you to assign it the appropriate number of ports.
NOTE:
The Modify button will only be available if a confi gurable switch is selected.
To access the Devices dialog box:
1. Press
Print Screen. The Main dialog box will appear.
2. Click Setup - Devices. The Devices dialog box appears.
Figure 4-5. Devices Dialog Box
When the ServSelect II appliance discovers a cascade switch, you will notice the
port numbering change to accommodate each server under that switch. For example,
if the switch is connected to ARI port 6, the switch port would be listed as 06 and
each server under it would be numbered sequentially 06-01, 06-02 and so on.
