724-746-5500 | blackbox.com
Page 102
Chapter 7: Command-Line Management
3. Command Syntax:
restore default
4. Example:
The following example restores the default setting of the switch:
switch_a#restore default
switch_a#
Auto Save:
1. Command Mode: Configure mode
Logon to Configure Mode (Configure Terminal Mode).
The switch_a(config)# prompt will show on the screen.
switch_a(config)#
2. Usage:
Use this command to enable auto save configuration function. The configuration will automatically be saved at every configured
interval when this command is enabled. Use the no form of this command to disable this feature.
3. Command Syntax:
service auto-config enable
no service auto-config enable
4. Example:
The following example enables or disables auto save the configuration to the switch:
switch_a(config)#service auto-config enable
switch_a(config)#no service auto-config enable
switch_a(config)#
Auto Save Interval (5–65536 sec):
1. Command Mode: Configure mode
Logon to Configure Mode (Configure Terminal Mode).
The switch_a(config)# prompt will show on the screen.
switch_a(config)#
2. Usage:
Use this command to set the interval when the configuration will automatically be saved. The range of interval value is from 5 to
65535. The default value is 30 seconds.
3. Command Syntax:
service auto-config interval WORD
WORD specifies the interval value.
