724-746-5500 | blackbox.com
Page 195
Chapter 7: Command-Line Management
switch_a(config)#
2. Usage:
Use this command to set the GMRP forward all option for an interface.
3. Command Syntax:
set gmrp fwdall enable | disable IF_NAME
IF_NAME Interface name.
4. Example:
The following example enables GMRP forwarding on a Layer-2 switch for interface fe1 (port 1):
switch_a(config)#set gmrp fwdall enable fe1
switch_a(config)#
Set GMRP Timer:
1. Command Mode: Configure mode
Logon to Configure Mode (Configure Terminal Mode).
The switch_a(config)# prompt will show on the screen.
switch_a(config)#
2. Usage:
Use this command to set the values for the GMRP Join, Leave, and Leaveall timers for a specified bridge. The default is the join
timer (200 milliseconds); the leave timer is 600 milliseconds (ms); and the leaveall timer is 10000 milliseconds (ms).
3. Command Syntax:
set gmrp timer [join | leave | leaveall] TIMER_VALUE IF_NAME
join Type of timer
leave Type of timer
leaveall Type of timer
TIMER_VALUE Timervalue in centiseconds.
IF_NAME Specify the name of the interface.
4. Example:
The following example sets the join timers 100 centiseconds for interface fe1 (port 1):
switch_a(config)#set gmrp join timer 100 fe1
switch_a(config)#
DHCP Server
DHCP Binding Table:
1. Command Mode: Privileged Exec mode
Logon to Privileged Exec Mode (Enable Mode).
The switch_a# prompt will show on the screen.
switch_a#
