Chapter 3 Configuring Devices
Using the Templates
3-12
User Guide for the CiscoWorks 1105 Wireless LAN Solution Engine
78-14092-01
Step 5 Select one of the following:
• Preview to see your changes before you apply them. (See Previewing the
Template, page 3-89.)
• Finish to save the template. (See Finishing the Template, page 3-89.)
• Another template category to configure more options. (See Template
Categories, page 3-2.)
Defining Ethertype Filters
Procedure
Step 1 Select Association > Ethertype Filters. The Association: Ethertype Filters
dialog box appears.
Step 2 Using this option:
• Create new filters—See Creating New Ethertype Filters, page 3-12.
• Delete the Filters—See Deleting Ethertype Filters, page 3-14.
Using this option you can also:
• Create Special Cases —See Creating Special Cases, page 3-14.
• Delete Special Cases—See Deleting Special Cases, page 3-16.
Creating New Ethertype Filters
Procedure
Step 1 To create and enable protocol filters for the access point’s Ethernet port, enter the
following:
Table 3-3 Creating New Ethertype Filters Settings
Field Description
Add New Ethertype Filter
Set ID Enter an identification number for the filter set.
