7-5
Cisco Unified IP Phone 7940G/7960G Administration Guide for Cisco Unified CallManager 4.2(3)
OL-8555-02
Chapter 7 Monitoring the Cisco Unified IP Phone Remotely
Network Configuration
Network Configuration
The Network Configuration area on a phone’s web page displays network
configuration information and information about other phone settings. Table 7-2
describes these items.
You can view and set many of these items from the Network Configuration Menu
the Cisco Unified IP Phone. For more information, see Chapter 4, “Configuring
Settings on the Cisco Unified IP Phone.”
To display the Network Configuration area, access the web page for the phone as
described in the “Accessing the Web Page for a Phone” section on page 7-2, and
then click the Network Configuration hyperlink.
Phone DN Directory number assigned to the phone
App Load ID Identifier of the firmware running on the phone
Boot Load ID Identifier of the factory-installed load running on the
phone
Version Version of the phone hardware
Expansion Module 1 Phone load ID for the first Cisco Unified IP Phone
7914 Expansion Module if connected to the phone
Expansion Module 2 Phone load ID for the second Cisco Unified IP Phone
7914 Expansion Module, if connected to the phone
Hardware Revision Version of the phone hardware
Serial Number Serial number of the phone
Model Number Model number of the phone
Codec Codec used by the phone
Amps Indicates whether 3 volt or 5 volt amplifier is being
used by the phone
C3PO Revision Revision of the Cisco 3 port switch in the phone
Message Waiting Indicates if there is a voice message waiting on any
line for this phone
Table 7-1 Device Information Area Items (continued)
Item Description
