2-13
Cisco Unified IP Phone Administration Guide for Cisco Unified Communications Manager 8.6 (SCCP and SIP)
OL-23091-01
Chapter 2 Preparing to Install the Cisco Unified IP Phones on Your Network
Determining the MAC Address for a Cisco Unified IP Phones
Converting an In-Use Phone from One Protocol to the Other
For information on how to convert an in-use phone from one protocol to the other, see the Cisco Unified
Communications Manager Administration Guide, chapter
Cisco Unified IP Phone Configuration.
Deploying a Phone in an SCCP and SIP Environment
To deploy Cisco Unified IP Phones in an environment that includes SCCP and SIP and in which the
Cisco
Unified Communications Manager Auto-Registration parameter is SCCP, perform these general
steps:
1. Set the Cisco Unified Communications Manager Auto Registration Protocol enterprise parameter to
SCCP.
From Cisco Unified Communications Manager Administration, choose System > Enterprise
Parameters.
2. Install the phones.
3. Change the Auto Registration Protocol enterprise parameter to SIP.
4. Auto-register the SIP phones.
Determining the MAC Address for a Cisco Unified IP Phones
Several procedures described in this manual require you to determine the MAC address of a
Cisco
Unified IP Phone. You can determine a phone MAC address in these ways:
• From the phone, press the Settings button, select Model Information and look at the MAC Address
field.
• Look at the MAC label on the back of the phone.
• Display the web page for the phone and click the Device Information hyperlink.
For information about accessing the web page, see Accessing the Web Page for a Phone, page 7-2.
