SPA9000 Field Reference
Voice tab
SPA9000 Voice System Administration Guide 251
B
Voice tab > FXS 1/2 page
FXS Port Polarity Configuration section
Voice tab >
Line 1/2/3/4 page
You can use the Line 1 - Line 4 pages to configure the line interfaces on your
SPA9000. The line interface page includes the following sections:
• “Line Enable section,” on page 252
• “Network Settings section,” on page 252
• “SIP Settings section,” on page 252
• “Subscriber Information section,” on page 255
• “Dial Plan section,” on page 256
• “NAT Settings section,” on page 256
• “Proxy and Registration section,” on page 257
FAX Tone Detect Mode: The method of fax tone dection: caller and callee, caller only,
or callee only
Default: caller or callee
NOTE This setting allows a fax tone to be detected from
either side of the call.
Idle Polarity Polarity before a call is connected: Forward or Reverse.
Default: Forward
Caller Conn Polarity Polarity after an outbound call is connected: Forward or
Reverse.
Default: Forward
Callee Conn Polarity Polarity after an inbound call is connected: Forward or
Reverse.
Default: Forward
