A SERVICE OF

logo

2–8 Configuring an HSZ80 Array Controller
10. Enter any other optional CLI commands for your configuration.
See “Optional Steps,” page 2–22 and Chapter 5, “CLI Commands.”
11. Display details about the controller you configured. Use the following command:
SHOW THIS_CONTROLLER FULL
See “SHOW” in Chapter 5, “CLI Commands.”
IMPORTANT: If you are using a PC or terminal with the maintenance port cable,
you must connect the SCSI bus cables in the desired configuration. See “Con-
necting a Single Controller to the Host,” page 2–9,for more information about
configurations.