EN Control panel messages 9
1
CANNOT DUPLEX CLOSE REAR BIN
The printer cannot duplex because the rear output bin is open.
1. Close the rear output bin door.
2. If the error message does not clear, turn the printer off and then on.
CANNOT DUPLEX CHECK REAR BIN
alternates with
CANNOT DUPLEX CHECK PAPER
The printer cannot duplex because the rear output bin is open or the
media is not supported by the duplex unit.
1. Close the rear output bin.
2. If the error message does not clear, turn the printer off and then on.
Verify that the media is supported by the duplex unit. See “Supported
media weights and sizes” in Chapter 5.
CHECKING PRINTER
The printer is performing an internal test. This process should take
approximately 30 seconds. The message appears during the initiation
of the engine test. When finished, the printer goes online.
l When the test has finished press Go to return the printer to the
READY state.
CLEARING PAPER FROM PRINTER
The printer has jammed or was turned on and media was detected in
the paper path. The printer is attempting to clear these pages.
l No action is required.
CLOSE FRONT DUPLEX DRAWER
The duplex drawer is not completely closed.
l Close the duplex drawer.
www.GovTechMedia.com
