EN Control panel messages 31
1
49 04E7
(continued)
Note
This error is primarily associated with the firmware and should not
require a new formatter.
49 04FF
A large print job (800 to 1200 pages) or complex graphics can cause
the printer to quit printing.
Two courses of actions are available:
l Determine the page that is causing the failure. If there is an image
on the page, try to move the image down on a portrait page or left
on a landscape page to move the image out of the strip that is
failing. The movements will need to be very small so as not to
cause the next strip to fail.
l Put the printer in Lossy mode with a sequence of PJL commands.
(Lossy compression is the process of compressing a file such that
some data is lost after the file is compressed and decompressed.)
Use the following series of commands to put the printer into Lossy
mode:
ESC%-12345X@PJL
@PJL Default Service mode=HPBOISEID
@PJL Default Diagnostics=ON
@PJL Enter Language = PCL
ESC%-12345X@PJL
Esc*z9999P
Esc*z50P
Esc*z201X
To turn off Lossy mode once the file has printed, use the following
commands:
ESC%-12345X@PJL
@PJL Default Diagnostics=OFF
@JPL Default Service Mode=EXIT
@PJL EOJ
ESC%-12345X@PJL
(Continued on next page.)
www.GovTechMedia.com
