Service Tests and Utilities
4-4
HP DesignJet 5000 and 5500 Series Printers Service Manual
Spinning up disk Boot Failed:1f500XX
This is an error related
to the Hard Disk
Drive, either the
connections are bad or
the Hard Disk Drive or
the Main PCA are
defective.
Unplug the Printer, remove the HDD
cover and check that the two cables (a
flat one and the power cable) are
connected. Also check that the flat
cable connector is clipped in correctly.
If the problem persists, replace the Hard
Disk Drive Page 8-74.
If the problem continues, check that the
Green and Orange LED’s on the Main
PCA are ON. If they are not ON,
probably the PWS or its connections are
defective. If the two LED’s are ON and
the error continues, replace the Main
PCA Page 8-81.
Spinning up disk...OK
Loading
firmware.fmw
Boot FAILED
Download the Firmware file to the Printer
Page 9-13.
Initializing
Initializing L2C
Initializing CLK
Initializing IO
BOOTROM ERROR:
Current Version:XXX
Necessary
Vers ion :X XX
Replace and Restart
The BootROM version does not support the
firmware installed on the HDD. Replace
the BootROM.
COMPONENT
MISMATCH:
You are running a
XXX printer with a
XXX disk
Insert XXX disk and
restart.
The firmware installed on the HDD and the
BootROM personality does not match.
Make sure both parts are either RTL or PS
and make sure you do NOT mix them (See
Parts List for Part Numbers).
Initializing
Please Wait
Code rev:XXXXXX
BootROM:XXXXX
RAM present:XXX MB
Hard Disk:XXXX MB
PS Code rev:XXXXX (Only in PS Unit)
Ready or
Ready for Media
Self Diagnostics - Initialization Sequence
LED’s Front Panel Message Printer Error - Error
Message/Code
Corrective Action
Max. Quality
Productivity
Max. Speed
Max. Quality
Productivity
Max. Speed
Max. Quality
Productivity
Max. Speed
Max. Quality
Productivity
Max. Speed
