Service Tests and Utilities
4-17
HP DesignJet 5000 and 5500 Series Printers Service Manual
Turn DRIVE ROLLER
The purpose of this Service Utility is to rotate the Overdrive, Drive
Roller and Roller Mark in order to clean them.
NOTE Remove the media before performing this operation. If media is
detected, the message below is displayed.
Perform the Turn DRIVE ROLLER utility as follows:
1. Lift the Window on the printer and deactivate the Window Sensor
by inserting a pencil in the Sensor slot on the top of the Right Trim.
2. In the Service Utilities submenu, scroll to "Turn DRIVE ROLLER"
and press Enter.
3. Once the utility starts, the Drive Roller will begin to turn slowly and
the following message will be displayed. Everytime the Drive
Roller completes a turn, the counter will increase by one.
4. If you want to stop the Drive Roller from turning, press Cancel and
the following message will appear on the front panel. Press Enter if
you want to return to the Service Utility menu or press Back if you
want to continue turning the Drive Roller.
1.1 Turn DRIVE ROLLER
Please remove media
completely
Press ENTER to continue
1. Service Utilities
1.3 Altitude Setup
1.2 Prime TUBES
1.4 EEROM Setup
1.5 Reset Life Counters
1.6 Backup EEROM
Top
Enter
Back
n
p
Press Enter
Make Selection
1.1 Turn DRIVE ROLLER
1.1 Turn DRIVE ROLLER
1 turn (s)
Press CANCEL to stop
Cancel
Press Cancel
Top
Enter
Back
n
p
Make Selection
1.1 Turn DRIVE ROLLER
Stopped!
Press ENTER to exit
or BACK to resume
