Diagnostic tools 79
3. Press Enter twice without entering anything in the new and confirm password fields.
4. Press F10 to save the changes you made and close the Setup Utility.
The Admin Password field value is set to Clear.
To reset the admin password:
If you forget the admin password, you need to clear the CMOS and reset the BIOS settings to regain
access the Setup Utility. For instructions, see “Clearing CMOS” section on page 97.
Exit menu
Field Description
Save Changes and Exit Saves changes made and closes the Setup Utility.
Keyboard shortcut: F10
Discard Changes and Exit Discards changes made and closes the Setup Utility.
Discard Changes Discards all changes made to the Setup Utility and loads the previous
configuration settings.
Load Optional Defaults Loads the factory-default settings for all Setup fields.
Keyboard shortcut: F9
Summary screen
The Summary screen displays basic and important information about the current server configuration
and is necessary for troubleshooting and may be required when asking for technical support. It is
recommended that you check this screen during the initial system setup and each time you install,
remove, or upgrade accessories.
To view the Summary screen:
You first need to enable the display of the Summary screen during bootup. Follow the steps below.
