A SERVICE OF

logo

Installing Or Replacing Parts And Accessories
Replacing The System Fan
Chapter 6
148
Replacing The System Fan
Removing The Fan
1. Switch off the display and workstation. Disconnect all power cables and any LAN or
telecommunications cables.
2. Remove the workstation’s cover (refer to page 119 for instructions).
3. Holding the fan with one hand, use a screwdriver to gently push the retaining clips
in the direction shown by the arrows on the chassis, then slide the fan up and out of
the chassis.
Figure 6-25 Removing the Fan
4. Disconnect the fan connector from the CHASSIS_FAN socket on the system board.
3
3
4