Configuration Menu Settings
Control Panel 2-17
Control Panel
Tip To make configuring the Imageshift and Customsize settings easier, set the units to
"MM" and make a coarse setting. Then, use a finer unit setting to fine tune the adjustment.
Customsize.height
5155 (min)
= 12240
12240(max)
This setting specifies the width dimensions of custom paper.
The table below lists the minimum and maximum custom paper
height in units, an incremental adjustment. The factory default
unit scale is 1/720", but you can reset the unit size with the unit
setting (see “Unit” on page 2-17).
customsize.height inch
milli
meter
Unit Size Setting
1/100" 1/200" 1/300" 1/600" 1/720" MM
Minimum 7.17 182 716 1432 2148 4296 5155 182
Maximum 17.0 431.8 1700 3400 5100 10,200 12,240 432
Unit
1/100"
1/200"
1/300"
1/600"
1/720"
MM
Sets the unit values used in customsize and imageshift.
Dpi
200 dpi
300 dpi
=600 dpi
Sets the print resolution for graphic images in dots per inch (dpi).
Clip
OFF
=ON
The D640 is able to print an image across the entire surface of the
physical paper. The image is clipped to prevent an image from
printing within 1/6th inch of any paper edge. This ensures optimum
print quality for the printed image.
If you don’t want this automatic clipping, you can set the printer to
Clip = OFF.
Even with Clip = OFF, the image will only print to the edge of the
paper if your print job contains the appropriate commands. See
“Setting Up Edge-to-Edge Printing” on page 6-23 for more
information.
Jamrecovery
=ON
OFF
When a paper jam occurs, the printer reprints all pages that did not
completely exit the printer’s paper path. If you do not want pages to
automatically reprint after a paper jam is cleared, set Jamrecovery =
OFF.
Economode
=OFF
ON
This setting specifies economy mode. When it is used for printing
drafts, you can save up to 30 percent of your toner consumption. In
economy mode solid black areas are filled in with a hatched pattern.
When economode is ON, the economode mark (e) appears in the
Control Panel, as shown in Figure 2-15.
