A SERVICE OF

logo

Open as PDF
next previous
Fuser
1. Before proceeding, remove the following components:
●
Rear-door assembly. See
Rear-door assembly on page 62.
●
Right-rear cover. See
Right-rear cover on page 68.
2. Duplex models only: Release two tabs (callout 1) on the duplex media-feed guide, and then slide
the guide toward the back of the product to remove it.
Reinstallation tip Make sure that both tabs snap back into place when reinstalling the duplex
media-feed guide.
Figure 2-81 Remove the fuser (1 of 4)
1
3. Disconnect three connectors (callout 1), and release one wire harness from the retainer (callout 2).
Figure 2-82 Remove the fuser (2 of 4)
1
2
100 Chapter 2 Removal and replacement ENWW