A SERVICE OF

logo

3. Disconnect one connector (callout 1; J14), release the wire harness from the guide (callout 2), and
then remove two screws (callout 3).
Figure 2-47 Remove the front-right and right-side cover assembly (2 of 6)
1
2
3
4. Slightly push the cover assembly toward the front of the product to release it, and then carefully
rotate the cover away from the product.
CAUTION: Do not damage the covers or the cartridge-door assembly (if you did not remove it)
when you rotate the cover assembly away from the product.
Do not dislodge the power-switch assembly (callout 1) when you rotate the cover assembly away
from the product.
Figure 2-48 Remove the front-right and right-side cover assembly (3 of 6)
1
ENWW Removal and replacement procedures 77