46 Kaspersky
®
Administration Kit
If the package for the remote installation of the Network Agent has been deleted,
then in order to create it again, select file klnagent.kpd located in the NetAgent
folder of the Kaspersky Administration Kit distribution package to be used as the
file that contains the description
The settings of the Network Agent installation contain a minimum set of settings
required to ensure the functioning of the component immediately following its
installation. The values of the settings match the values of the default application
settings. If required, these can be changed using the Settings and the
Administration Group tabs of the installation package properties window.
The Settings tab (see Figure 21) contains settings used by the Network agent
after it is installed on the client computers to connect to the Administration Server
(by default, values of the current server will be used during the creation).
• Address of the computer on which the Administration Server is installed.
• Number of port used for unsecured connection to the Administration
Server. By default port 14000 is used. If this port is busy, you can change
it.
• Number of port used for secure connection to the Administration Server
using SSL protocol. By default port 13000 is used.
Only decimal representation is allowed.
• Certificate file for authentication of the access to the Administration
Server. The value of this setting is determined by the Use the Server
Certificate box.
If the box is not checked by default, the certificate file will be automatically
obtained from the Administration Server when the Agent connects to it for
the first time.
If the Use Server Certificate box is checked, authentication will be
performed based on the certificate file specified using the Browse button.
This file has extension .cer and is located in the Cert folder of the
Kaspersky Administration Kit installation folder. You can change the
certificate file by selecting the file you need using the Browse button.
• Which port will be used by the Network Agent to connection to the Server:
simple or secure. The value of this setting is determined by the Use SSL
connection box. If the box is checked, the connection is performed via a
secure port using SSL protocol, if the box is unchecked, the connection is
performed via an unsecured port.
• The proxy server connection settings. If a proxy server is used by the
Network Agent to connect to the Server, check the Use proxy server
