A SERVICE OF

logo

Open as PDF
next previous
9898 99
Return to the Top page
Setting Up
Return to the Top page
Setting Up
AV Output Interface Setup
YoucanselectanAVsourcetobeoutputat
theAVOUTPUTport.Defaultis“VIDEO1”.
1 Touch [Menu] on any screen.
2 Touch [SETUP].
SETUP Menu screen appears.
3 Touch [AV-OUT].
AV-OUT Interface screen appears.
4 Touch [2] or [3] to set [AV-OUT] to
VIDEO, DISC, iPod, or OFF.
External Device Control
Controltheexternaldevicepowersupply.
1 Touch [EXT SW] in the Source Control
screen.
EXT SW Control screen appears.
NOTE
•If [EXT SW] is not displayed, touch [ ].
2 Touch the desired switch key.
You can turn on or off the external device
power supply.
NOTE
•You must connect a commercially available relay
unit in order to use this function. Connect the
external device to be controlled to that relay unit.
•See EXT SW setup (P.90) for information on
setting the power on or off specification.
AV Input Setup
YoucansetAVinputparameters.
1 Touch [Menu] on any screen.
2 Touch [SETUP].
SETUP Menu screen appears.
3 Touch [Source].
4 Touch [AV-IN SETUP] in the list.
AV-IN SETUP screen appears.
5 Set each item as follows.
iPod AV Interface Use*
1
Sets the terminal which iPod is connected.
Setting values are iPod and AV-IN2.
iPod (Default): Set this when an iPod is
connected using KCA-iP202
connector. You can listen to
audio or watch video in your
iPod as iPod source.
AV-IN2: Set this when an iPod is connected
using KCA-iP102 connector.You can
listen to audio in your iPod as iPod
source. You can also listen to audio or
watch video output from a AV device
as AV-IN2 source.
AV-IN1 Name/AV-IN2 Name*
2
Sets a name to be displayed when you select
a system that is connected via the AV INPUT
port. Default is “VIDEO”.
*1ThisitemcanbesetwheninSTANDBY
sourceandalsotheiPodisdisconnected.
*2[AV-IN2Name]becomessettablewhen
“AV-IN2”isselectedin[iPodAVInterface
Use].