A SERVICE OF

logo

Open as PDF
next previous
61
7532 Commissioning
Note!
The dip table can be printed out using the ToF-Tool. Before doing this, the ToF Tool
must be reconnected to the instrument in order to update the values within the ToF Tool.
Note!
Make your inputs into the dip table in semi-automatic mode. We advise you to leave
"auto correction" (031) activated ("on") while you enter your inputs.
Caution!
After entering one or more points into the dip table, make sure that the dip table is
activated and left in the "table on" dip table mode.
Function "dip table state" (037)
This function displays the dip table status.
Display:
•table on
• table off
table on
Indicates whether the dip table is active.
table off
Indicates whether the dip table is not active.
Function "dip table mode" (033)
The dip table can be switched on or off using this function.
Selection:
• manual
• semi-automatic
•table on
• table off
•clear table
•view
⇒
E
+
–
⇒
E
+
–